Home
href="
52079  
Part No. WTR064  
Accurately Displays  
Current Outdoor Temperature and  
Enables Dual Fuel* and  
Automatic Humidity* Capability  
on the LUXPRO® Thermostat  
* SELECTED MODELS ONLY  
Before you begin, make sure that the time on the LUXPRO® thermostat is set.  
If not, set the time before starting the installation.  
INSTALLATION INSTRUCTIONS  
1. Install the included 2 AA batteries by removing the 4 screws located at the back of the  
transmitter. The LED on the transmitter will flash every 6 seconds. Do not close the  
battery compartment yet.  
2. Remove the top cover of the thermostat and plug the receiver into the white connector  
located to the bottom left under the touch screen. (A)  
3. Place the antenna wire into the 4th vent as shown (B).  
Clip the receiver into the 1st vent (C).  
4. Press the “RESET” button (D) on the receiver module for 10 seconds to activate the  
transmitter and receiver. The outdoor temperature will appear on your thermostat within  
5 minutes. Make sure that the dot to the left of the outdoor temperature (E) flashes  
approximately every 15 seconds. If after 5 minutes the outdoor temperature is not  
displayed on the thermostat or if the dot to the left of the outdoor temperature (E) is not  
flashing, unplug the receiver module from the thermostat, remove batteries from the  
transmitter and start the installation procedure again.  
5. Close the battery compartment and position the transmitter in a permanent location that  
is sheltered from the elements. After placing the transmitter in a permanent location,  
ensure that the dot to the left of the temperature (E) flashes approximately every 15  
seconds. If the dot to the left of the temperature (E) is not flashing, change the  
transmitter location.  
6. Use the chart below as a reference for the recommended humidity settings.  
WARNING: Adjusting the humidity control higher than the recommended setting may cause  
condensation, resulting in possible damage to the home.  
E
A
D
C
B
HUMIDITY SETTING RECOMMENDATIONS  
At Outside Temperatures Of:  
Humidity Setting:  
-20°F (-29°C)  
-10°F (-23°C)  
0°F (-17°C)  
+10°F (-12°C)  
+20°F (-6°C)  
15 %  
20 %  
25 %  
30 %  
35 %  
40 %  
Over +32°F (0°C)  
© 2009 LUX PRODUCTS CORPORATION. ALL RIGHTS RESERVED  
href="
OBTAINING WARRANTY SERVICE:  
Customer must contact and return product to a local LUX Products Corporation product  
dealer or installer within the applicable warranty period to obtain warranty service. Dated  
proof of original purchase will be required.  
HARDWARE:  
LUX Products Corporation warrants the original end user (“Customer”) that new LUXPRO®  
branded products will be free from defects in workmanship and materials, under normal  
use, for three (3) years from the original purchase date.  
SOFTWARE:  
LUX Products Corporation warrants to Customer that the LUXPRO® thermostat software will  
perform in substantial conformance to its program specifications a period of three (3) years  
from the date of the original purchase.  
EXCLUSIONS:  
This warranty excludes (1) physical damage to the surface of the product, including cracks  
or scratches on the touch-screen or outside casing; (2) damage caused by misuse, neglect,  
improper installation, unauthorized attempts to open, repair, or modify the product, or any  
other cause beyond the range of intended use; damage caused by accident, fire, power  
changes, other hazard, or Acts of God; (4) use of the product with any device if such device  
causes the problem.  
EXCLUSIVE REMEDIES:  
Should a covered defect occur during the warranty period and Customer notifies LUX  
Products Corporation, Customer’s sole and exclusive remedy will be, at LUX Products  
Corporation’s sole option and expense, to repair or replace the product. Replacement  
products or parts may be new or reconditioned or a comparable version of the defective  
item. LUX Products Corporation warrants any replaced product or part for a period of ninety  
(90) days from shipment, or through the end the original warranty, whichever is longer.  
WARRANTY EXCLUSIVE:  
THE FORGOING WARRANTIES AND REMEDIES ARE EXCLUSIVE AND IN LIEU ALL OTHER  
WARRANTIES, EXPRESS OR IMPLIED, INCLUDING WARRANTIES MERCHANTABILITY,  
FITNESS FOR A PARTICULAR PURPOSE, CORRESPONDENCE WITH DESCRIPTION, AND  
NON INFRINGEMENT, ALL OF WHICH ARE EXPRESSLY DISCLAIMED BY LUX PRODUCTS  
CORPORATION AND ITS SUPPLIERS.  
DISCLAIMER:  
NEITHER LUX PRODUCTS CORPORATION NOR ITS SUPPLIERS SHALL BE LIABLE FOR  
INCIDENTAL, CONSEQUENTIAL, INDIRECT, SPECIAL, OR PUNITIVE DAMAGES OF ANY  
KIND, OR FINANCIAL LOSS ARISING OUT OF OR IN CONNECTION WITH THE SALE OR USE  
OF THIS PRODUCT, WHETHER BASED IN CONTRACT, TORT (INCLUDING NEGLIGENCE) OR  
ANY OTHER THEORY, EVEN IF LUX PRODUCTS CORPORATION HAS BEEN ADVISED OF THE  
POSSIBILITY OF SUCH DAMAGES. LUX PRODUCTS CORPORATION’S ENTIRE LIABILITY  
SHALL BE LIMITED TO REPLACEMENT OR REPAIR OF THE PRODUCT.  
FCC STATEMENT: THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION  
IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE  
HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE  
RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.  
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE  
CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS  
COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT. THIS DEVICE HAS  
BEEN DESIGNED TO OPERATE WITH THE INCLUDED ANTENNA, AND HAVING A MAXIMUM  
GAIN OF 0 dBd. ANTENNAS NOT INCLUDED OR HAVING A GAIN GREATER THAN 0 dBd ARE  
STRICTLY PROHIBITED FOR USE WITH THIS DEVICE. THE REQUIRED ANTENNA  
IMPEDANCE IS 52 OHMS.  
U.S. Patent: 6,902,117